IEC / EN 61000-4-6 specifies the design and performance of a range of coupling /de-coupling networks (CDNs). Each CDN is specific to the type of cable and the intended signal carried on the cable. AMETEK CTS with its brand TESEQ offers an extensive range of CDNs which fully comply with the requirements of the standard and provide a simple and reliable method of injecting RF energy into the equipment under test (EUT). In this datasheet, CDN used with unscreened unbalanced for data communications with different line application starting from 150 kHz as required by IEC / EN 61000-4-6 is presented. The CDN CAN series is used to Inject common mode disturbance signal into unscreened and unbalanced high speed CAN Bus with low currents in the frequency range from 10 kHz to 80 MHz and from 150 kHz to 230 MHz. CDN CAN U5 can be used to inject the disturbed signal into the ground line.

符合 IEC/EN 61000-4-6 標準的耦合/去耦網路 (CDN)

IEC/EN 61000-4-6 規範了一系列 耦合/去耦網路 (CDN) 的設計與性能要求，每種 CDN 均針對特定類型的電纜及其所傳輸的信號。AMETEK CTS 旗下品牌 TESEQ 提供廣泛的 CDN 產品，完全符合標準要求，並為設備測試 (EUT) 提供簡單且可靠的射頻能量注入方法。

本技術資料介紹了用於無遮蔽、不平衡數據通訊線路的 CDN，適用頻率範圍 自 150 kHz 起，符合 IEC/EN 61000-4-6 要求。

CDN CAN 系列 用於在 無遮蔽、不平衡的高速 CAN Bus 內注入 共模干擾信號，適用頻率範圍為 10 kHz 至 80 MHz 及 150 kHz 至 230 MHz。其中 CDN CAN U5 可用於將干擾信號注入地線。

• Coupling networks designed for IEC/EN 61000-4-6
• Used for CAN BUS application
• D-Sub-9-sockets
• Models with frequency range from 10 kHz to 80 MHz and from 150 kHz to 230 MHz

• 符合 IEC/EN 61000-4-6 標準的耦合網路
• 適用於 CAN BUS 應用
• D-Sub 9 接頭
• 提供 10 kHz 至 80 MHz 及 150 kHz 至 230 MHz 兩種頻率範圍的型號

• IEC / EN Basic Standards : IEC 61000-4-6
• CISPR Standards : CISPR 15 CISPR 24
• IEC / EN Generic Standards : EN 61000-6-1 EN 61000-6-2
• IEC / EN Product Standards : IEC 60533 IEC 60601-1-2 IEC 61326
• National Standards : NAMUR NE 21